SS316L
UNS S31603 / EN 1.4404
Code S6. Austenitic grade with 2–3 % molybdenum and low carbon. Typically chosen where chlorides or process chemicals are present.
CML tube fittings are listed in SS316L, SS304 and Duplex 2205. Composition limits below are from ASTM A479.
UNS S31603 / EN 1.4404
Code S6. Austenitic grade with 2–3 % molybdenum and low carbon. Typically chosen where chlorides or process chemicals are present.
UNS S30400 / EN 1.4301
Code S4. Austenitic chromium-nickel grade without molybdenum. Typically chosen for general-purpose service in milder environments.
UNS S32205 / S31803, EN 1.4462
Code DP. Austenitic-ferritic grade with higher chromium, molybdenum and nitrogen. Typically chosen where higher strength or resistance to chloride stress corrosion cracking is needed.
Limits in percent by weight, maximum unless a range is shown, from ASTM A479/A479M (ASME SA-479, 2023 edition), Table 1. Iron is the balance. EN numbers are the corresponding EN 10088 designations.
| Grade | UNS | EN | C | Mn | P | S | Si | Cr | Ni | Mo | N |
|---|---|---|---|---|---|---|---|---|---|---|---|
| SS316L | S31603 | 1.4404 | 0.030 | 2.00 | 0.045 | 0.030 | 1.00 | 16.0–18.0 | 10.0–14.0 | 2.00–3.00 | – |
| SS304 | S30400 | 1.4301 | 0.08 | 2.00 | 0.045 | 0.030 | 1.00 | 18.0–20.0 | 8.0–10.5 | – | – |
| Duplex 2205 | S32205 | 1.4462 | 0.030 | 2.00 | 0.030 | 0.020 | 1.00 | 22.0–23.0 | 4.5–6.5 | 3.0–3.5 | 0.14–0.20 |
| Duplex 2205 | S31803 | 1.4462 | 0.030 | 2.00 | 0.030 | 0.020 | 1.00 | 21.0–23.0 | 4.5–6.5 | 2.5–3.5 | 0.08–0.20 |
Annealed condition, ASTM A479/A479M Table 2.
| Grade | UNS | Tensile strength, min. MPa | Yield strength, min. MPa |
|---|---|---|---|
| SS316L | S31603 | 485 | 170 |
| SS304 | S30400 | 515 | 205 |
| Duplex 2205 | S32205 | 655 | 450 |
| Duplex 2205 | S31803 | 620 | 450 |
These are standard limits for the grade, not test results for a specific lot. Pressure availability depends on tube O.D. and is listed on the Technical page. Material choice for a given medium and temperature remains the responsibility of the system designer.
Material test certificates (MTC) available on request. Ask us about material documentation with your inquiry. State the grade and any standard you need it to reference.
Try: